An excellent signal/noise ratio, a low harmonic distortion rate and a wide gain range make QuadMic II an excellent choice for studio quality recordings. But QuadMic can also feed on battery and is therefore excellent for nomadic applications.
The strengths
- 4 micro preampli inputs
- XLR/jack connectors for inputs
- 4 x line outputs
- Channel switchable ghost power
- Low cut per channel
- Inversion of phase by channel
- Battery compatible power
- Each of the 4 channels has microphone and line inputs on Neutrik XLR/symmetrical connector, a switchable 48v phantom power supply, phase inversion and a cut-down filter.
All channels are also equipped with LEDs for the presence of the signal, a stopwatch, and activation of the ghost power. Input amplification can be set from 6 to 60 dB. The output signals at the symmetrical line level are located at the rear of the device in the form of symmetric jacks 6.35 mm.
A maximum symmetrical and asymmetrical output level of +21 dBu makes QuadMic II the ideal partner of converters and interfaces RME having analog inputs.
The QuadMic II perfectly complements any system RME with line inputs by adding external microphone inputs. Since the unit operates on power voltages ranging from 9 to 18V DC, it can work on virtually any available power source, including rechargeable batteries and batteries.
- Large frequency response with special RF input filter
- Power supply: works with voltages ranging from 9-18V DC, 100-240 Volt
- Operation with virtually any continuous current source, including batteries (reloadable)
- Entry level max. XLR: +15 dBu
- Entry level max. jack : +21 dBu
- Output level max. +21 dB
- Signal/noise ratio: 129 dB EIN @ 150 Ohm
- Frequency response: 5 Hz - 200 kHz, - 0.5 dB
- High-pass filter to 80 Hz, 18 dB / oct
- 4 x preamplis micro in combo XLR/ack
- 4 symmetrical line outputs on jack 6.35
- Ghost power supply via channel
- Cut by channel
- Channel phase inverter
- DC power supply, compatible with batteries
